Carts are available for early shipment
Assembly Instructions
Step 1
Step 1
Step 1
Take one base cart and set it with the wheels down on the ground. Remove cable ties by removing the tape from the base pad.
Step 2
Step 1
Step 1
Take one sidewall, with the sealed edge up, and separate the two sides to open into a
rectangular shape.
Step 3
Step 1
Step 3
Place the sidewall over top of the base cart and slide it down into the metal frame. It should fit in the “groove” created between the grey base pad and the metal sides of the frame. Push down to make sure the sidewalls are resting on the metal cart and the holes on the shorter ends of the sidewall line up with the holes in the metal frame.
Step 4
Step 1
Step 3
Insert those provided 175lb cable ties through the holes in the sidewalls and the base cart near the bottom of each shorter side of the cart. Secure the cable tie by inserting the flat end through the slot on the other end of the tie. Make sure the cable tie is NOT twisted. This can be done on the inside or outside of the cart. Pull tight and cut off the excess material if desired.